#Ownload thonny editor install
#Ownload thonny editor serial

Unfortunately, when I start it (as explain in the instructions, with the CTRL key), it does not start: it jumps on the dock and then exited automatically without any error prompts.

#Ownload thonny editor install

I downloaded mu-editor v1.0.3 from ' ' on my Mac (MacOSX 10.11.6 - ElCapitan) and managed to install it. Hi, I am new to this forum and I hope my question has not been answered already. I'll continue working on the last remaining tests and prompts, but let me know if you discover any other problems, annoyances etc. I found a way to make error messages refer to the right line numbers (finally!).I've changed a bit in how devices are recognized, making it possible to match on manufacturer strings (this part is especially important to get tested on Windows).A dropdown in the statusbar has been added, which only shows up when users connect one or more devices.

#Ownload thonny editor serial

REPL serial connections to MicroPython-devices are maintained as 'REPLConnection' objects, instead of being placed both in UI-code and inside modes.find_devices now returns a list of devices represented as special Device-objects.Here's the branch with my changes if you want to check it out: It would be nice if some of you could test that it works, especially Windows users and Linux users, as I'm currently only in posession of a Mac This also separates device-connections from the UI-code, so it should be easier to make future improvements. I still lack to do a few prompt ('You have just changed to a micro:bit device, do you want to change mode to the BBC micro:bit mode?') as well as a few tests. Now multiple devices can be connected and a small dropdown will be shown, to select between the devices. I've made a major overhaul of the MicroPython-modes (ESP-mode/micro:bit/CircuitPython). Does anyone have any advice for me? Thanks! I also tried to navigate directly to the board from the mu file browser but under /Volumes it doesn't 'see' the device. Would you like to change Mu to the Adafruit CircuitPython mode?' I selected 'OK' but then again received the message 'Could not find an attached Adafruit CiruitPython device'.

Then, upon restarting mu, it said 'Detected a new Adafruit CircuitPython device. Here is another experiment I did: I switched to Python3 mode before exiting mu. I have updated to the newest version of CircuitPython, have also erased and redone the filesystem and everything else I could think of (including reinstalling mu). I can, however, enter the REPL via mu in this circumstance and so mu is perfectly capable of talking to the board. I am experimenting with CircuitPython on Metro-series boards and I am having a recurring issue with all of the boards in that mu editor does not recognize that there is a device plugged in (even though it shows up as a drive on my Mac).